This KB article is intended to give users an understanding of how much data the Digi Remote Manager connector/client typically uses, for Digi products that run the modern DAL Operating System.
Average monthly data usage:
- 4.68MB on cellular connections
- 18.1 MB on non-cellular connections (wired Ethernet, Wi-Fi client, PPPoE, etc)
- no configuration/firmware updates
- DigiRM-related configuration settings at their defaults
- connection to DigiRM enabled
- keep-alives set to 290-seconds for cellular, 60-seconds for non-cellular
- health metrics set to once per hour
- device event logging disabled
Maximum monthly data usage: 263MB
- one configuration update with 50 config settings (approx 10kB in size)
- one firmware update included (approx 30 MB as the average DAL product firmware size, some platforms have smaller firmware some have larger)
- all DigiRM-related config settings enabled and tuned to their most-often frequency
- initial connection sequence to DigiRM along with query_state and query_setting RCI calls from DigiRM - 12.25kB
- device event logging enabled at 1/minute intervals - 137 MB per month
- keep-alives set to once per 30-seconds - 34 MB per month
- health metrics reported once per minute - 62.64MB per month
Minimum monthly data usage: 154 kB
- no configuration/firmware updates
- only critical DigiRM-related configuration settings enabled to maintain a base connectivity to DigiRM
- initial connection sequence to DigiRM along with query_state and query_setting RCI calls from DigiRM - 12.25kB
- keep-alives set to once per 2 hours - 141.84 kB
- device event logging disabled
- health metrics disabled
Last updated:
Jun 15, 2023